Portable ups power supply and maintenance considerations

Portable solar generator is a safe, portable, efficient and environmentally friendly small energy storage system that provides you with a portable and sustainable green energy solution. Pay attention to the following aspects when using and maintaining:Portable UPS is a safe, portable, efficient and environmentally friendly small energy storage system that provides you with a portable and sustainable green energy solution. Pay attention to the following aspects when using and maintaining:

1, the first charge must have skills
After purchasing a new portable UPS, the UPS should be plugged into a 220V power supply and charged for at least 12 hours to ensure that the battery is fully charged. If the UPS is not used for a long time. It should be turned on for 24 hours every 2 to 3 months to fully charge it, and let the UPS power supply be in the inverter for 2 to 3 minutes to ensure the normal life of the battery. When the UPS is turned on, the battery pack will be charged. Press and hold the power button for more than 1 second to turn on the inverter.

2, reasonable choice of installation location
A good installation location is very important. The place where the portable UPS is placed must be well ventilated. Keep away from water, flammable gases and corrosive substances. The ambient temperature should be between 0 and 40 °C. Keep the air inlet and air outlet open.

3. Install a portable solar generator
Pay special attention to the order of the zero line (N), the fire line (L) and the ground line (G), pay special attention to the ground line. When the system ground fault occurs, do not connect the ground wire to the portable UPS.

4, pay attention to the safe operation of the operator
Safety measures should also be taken when connecting the output power to a portable UPS. Since the output voltage and current of the portable UPS are relatively large, it is necessary to pay attention to safety when connecting the output power to prevent electric shock.

5. Power-on and power-off sequence when using a portable solar generator
The correct power-on shutdown sequence should be to first turn on the UPS to power it, then turn on various loads to avoid damage from transient current surges during startup to the portable UPS. In the order of shutdown, the load should be turned off before the UPS is turned off.

6, avoid using portable solar generator overload
When using a portable UPS, calculate the load size. In order to avoid overload or underload, overload will cause the UPS to be overloaded for a long time, shortening the service life of the portable UPS. If the load is too small, the portable solar generator operating circuit is in an abnormal state for a long time, which is also harmful to the UPS. A reasonable load should be controlled between 50% and 80%.

7, portable UPS can not be idle for a long time
For portable UPS power supplies that have not been used for a long time, charge the UPS power supply to the charging circuit in the machine for 12 hours before restarting the power supply. For standby portable solar generator , it is best to run the portable UPS in reverse every other month. The transformer is operated for 2 to 3 minutes to activate the battery.

8, operation and maintenance
Strictly follow the corresponding power operating procedures during operation. In daily use, all power outlets on the UPS load side should be strictly managed; it is best to distinguish them from the power outlets by color or other effective methods. Unused UPS outlets should be turned off or off. It is strictly forbidden to connect electrical equipment that is not related to the computer on the UPS socket, especially high-power tools.